???????....
5 minutes!!!!! quicker than I thought...............
???????....
. . . . . .
My Garmin stack is so deep that I need to cut into the subpanel to allow clearance for this depth. The question is, do I make a hole that allows the panel mounted racks to just "float" in this hole or do I make the hole tight enough to help support the back of the rack in some way? I know I will need to add support to the edges of the cuts.
. . . . . . .
Bruce,
Thats the panel I intend to install myself,not that I have anything against glass, it's just that I want it to seem more like an airplane than a video game.
Outstanding! Very clean and uncluttered. Well done.
Did you fabricate the sub panel? Did you document the construction? Metal or fiberglass?
How did you do your placards; they look great.
Thanks! Made from .050" aluminum, primed, painted white JetFlex, then brown JetFlex, and finally sent up to Aircraft Engravers http://www.engravers.net. They engrave through the top layer of paint into the middle of the paint layer below. Not cheap but the work they do is really top notch.
Here's your pic Paul K...looking good
Do Over In Progress
Bill, how did you do the labels.....at least THEY seem to have worked OK.
How did you handle the dual throttle quads?