N546RV
Well Known Member
OK, so I've got a pile of avionics on hand, and I'm finalizing all my little black box layouts and getting shelves fabricated, all preparatory to starting to build harnesses with a vengeance. The one remaining box I don't have on hand is the CPI2 controller, so I'm looking to get that ordered.
Question #1: What did you go with for your coil locations, and how do you feel about your choice? Currently I'm leaning towards one magneto and one case mount. Any potential packaging issues with this setup I should be aware of?
Question #2: What did your harness lengths end up looking like? Ross suggested 7.5' for the crank sensor harness and 6.5' for the coil packs. Based on my routing in the cabin I expect about a 4.5' run to the firewall penetration on the lower left side. Do 3' and 2' sound reasonable for the run from the penetration to the FWF items?
Question #infinity: Any other things you ran into during your install you wish you'd thought of ahead of time?
Thanks!
Question #1: What did you go with for your coil locations, and how do you feel about your choice? Currently I'm leaning towards one magneto and one case mount. Any potential packaging issues with this setup I should be aware of?
Question #2: What did your harness lengths end up looking like? Ross suggested 7.5' for the crank sensor harness and 6.5' for the coil packs. Based on my routing in the cabin I expect about a 4.5' run to the firewall penetration on the lower left side. Do 3' and 2' sound reasonable for the run from the penetration to the FWF items?
Question #infinity: Any other things you ran into during your install you wish you'd thought of ahead of time?
Thanks!