Scott Will
Well Known Member
While drilling the existing snap bushing holes bigger, I managed to mar the spar a very little amount with the side of my drill (see pic). I made sure to use tape around the drill to aviod this but it slipped off - guess I should have put it on the spar itself.
What's the best way to touch up the spar? Green (zinc chromate) primer OK - like they did in the countersink holes? The scratches are very fine and light... not as deep at all. Would you take a scotchbrite pad to the area, too?
Thanks for your help in advance.
Scott
What's the best way to touch up the spar? Green (zinc chromate) primer OK - like they did in the countersink holes? The scratches are very fine and light... not as deep at all. Would you take a scotchbrite pad to the area, too?
Thanks for your help in advance.
Scott