I’m planning out where to put my remote canopy release handle, and I had initially thought the bottom of the power module would be a good spot.
However, it seems my F-14188A Power module front plate is not the same as the one depicted in OP63? (It’s the same as in Section 59).
It’s like the cutout for the breakers is at the lower end of this plate, not the upper end? Leaving no way to attach the F-01452C cable mount plate? (It’s probably better for accessibility anyway that the breakers are lower down).
Has anyone else run into this?
In any case, I’m not convinced it’s a good place now anyway. It’s hard enough to get into where the fuel pumps are as it is.
Any other good spots people have found for the handle?
I was wondering if placed vertically on the seat cover plate might be an option? (On a removable plate perhaps).
However, it seems my F-14188A Power module front plate is not the same as the one depicted in OP63? (It’s the same as in Section 59).
It’s like the cutout for the breakers is at the lower end of this plate, not the upper end? Leaving no way to attach the F-01452C cable mount plate? (It’s probably better for accessibility anyway that the breakers are lower down).
Has anyone else run into this?
In any case, I’m not convinced it’s a good place now anyway. It’s hard enough to get into where the fuel pumps are as it is.
Any other good spots people have found for the handle?
I was wondering if placed vertically on the seat cover plate might be an option? (On a removable plate perhaps).