jamcgee1978
Active Member
Hi there,
New RV10 builder here in the UK happy easter hols to all,
Will be constructing my dimpler table tomorrow, as i understand i should build the level of the table to match the bottom dimple die ( to avoid pressing down on the material when dimpling)
Is this correct.
Also when using the Cframe bench dimpler should the male die remain on the bottom for ease of steadying the aluminium prior to dimpling.
Im yet to undertake the metal working course offered by the LAA so im learning metalwork via books and this great forum so far,
Thanks in advance
James
Glasgow, UK
New RV10 builder here in the UK happy easter hols to all,
Will be constructing my dimpler table tomorrow, as i understand i should build the level of the table to match the bottom dimple die ( to avoid pressing down on the material when dimpling)
Is this correct.
Also when using the Cframe bench dimpler should the male die remain on the bottom for ease of steadying the aluminium prior to dimpling.
Im yet to undertake the metal working course offered by the LAA so im learning metalwork via books and this great forum so far,
Thanks in advance
James
Glasgow, UK