RVV-10 Tail Cone Wiring Access

[dmjepsen]

Good day all;
I am about to close-out the rear seat and baggage areas in my RV-10 fuselage. Before I do, I am trying to figure out how best to route all of the various cables, wires, and static tube from the tail cone to the side panels in the mid-cabin area. Suggestions?

 

[Strikhedonia]

You can see where/how I ran mine in this post: http://www.strikhedonia.com/fk-lot-wires/

 

[dmjepsen]

Did you enlarge the two holes in the bottom left and right corners of F-1034A and F-1005A which were originally punched to 5/8" and if so, by how much?

 

[Carl Froehlich]

PM me your email address and I’ll provide photos. I run three conduits on each side, use five and have one spare.

Carl

 

[Strikhedonia]

I did not enlarge any holes. All wire runs were through stock holes, but I did not run any conduit (however I do have messenger lines run in case I need to add a cable later on).

Did you enlarge the two holes in the bottom left and right corners of F-1034A and F-1005A which were originally punched to 5/8" and if so, by how much?

 

[Vol88]

Conduit and access panels

Posts 17 & 18 here have photos of conduit and access panels in the rear seat and baggage area Baggage floor conduit and access panels

 

[rdamazio]

You can see mine here: https://www.airplane.build/2020/05/baggage-area.html