I just finished routing the wires in the Aft Fuselage and I seem to of ran into what I believe to be a problem. When inspecting the P724 wire I saw that some of the internal wiring was visible (image attached). Initially I thought that it was supposed to be like this, so I went ahead and routed the wires, but upon further inspection to wire isn't even attached (it can be removed). I'm doubtful that it's supposed to be like this and I'm wondering if there's anything what should do (it came in the kit like this)? Currently the wire is just nestled together so it doesn't fall off. Lastly while installing the standard pitot static, the instructions state that the static port should be hollow, with the mandrel removed. After pop riveting the first port I have what looks like a little bit of the mandrel still in the port near the shop end of the rivet (image attached). It can move around so air can get in and out, but I'm not sure if it should be removed or not? Thanks!
https://photos.app.goo.gl/MMfBEtZ6JEiSVKWR9
https://photos.app.goo.gl/g9Kjj4jAfk61aUp67
https://photos.app.goo.gl/gbQM4ScuV9kmHjVN9
https://photos.app.goo.gl/MMfBEtZ6JEiSVKWR9
https://photos.app.goo.gl/g9Kjj4jAfk61aUp67
https://photos.app.goo.gl/gbQM4ScuV9kmHjVN9