1/4 final drill 29-20

In step 3 on page 29-20 we are to final drill 1/4 the F-01457 gusset through to the roll bar angle and bulkhead side channel. Why is the F0140SF brace not put in place for that? It has the same 1/4 holes and get sandwiched in there later.

if your are talking about the f 1405f brace i dont see any where the plans mention reamming those holes in that part. It may be a small error in the plans. Its also not going to hurt to shoot all that stuff together then ream that brace. That away you know everything is sucked up to each other nice and tight.