What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Countersink W-1212 Hinge assembly lower left hole?

NZ_Pompey

Member
I've just started on my wing kit and on page 14-03 it calls out to countersink for CS4-4 rivets on the lower holes of the spar-doubler plates.
All good, but I just want to confirm that for the lower right hole on the spar doubler - this will be covered by the W-1212 hinge assembly, so assuming I need to countersink the hinge assembly lower left hole here instead on the left spar doubler, and the lower right hole on the right spar doubler?

Reading ahead to page 15-06 it looks like that hole is for a CS4-4 but not super clear from the pic.

Thanks,
Paul
 
Last edited:
Back
Top