What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Flap gap seal rivets on quickbuild wing.

Ralgh

Member
I have the quickbuild wings and have riveted all the holes on the flap gap seal which I can reach with a bucking bar. There is now way I can reach the rivets in the inboard section where the skin is already installed. I don't know if I messed something in the plans but I don't know which type of pull rivets to use for the remaining holes. Have I missed something or am I lacking some standard knowledge on the rivets I should use? And more importantly which rivets should I use? Thanks.
 
The rivets are in the one sheet of the QB wing instructions. It was hidden in the other literature that came with the QB. it can be found on the Van's website.

https://www.vansaircraft.com/service-information-and-revisions/14-qbw/

Complete Section 20 Bottom Wing Skins Page 20-02. When attaching the flap gap fairing, use CR3212-4-6 rivets for the six inboard locations and MSP-42 rivets elsewhere.

There is also a QB fuselage instructions.

https://www.vansaircraft.com/service-information-and-revisions/14-qbf/
 
Thank you. That is super helpful. I haven’t discarded anything and I went through all my paperwork and I don’t have any quickbuild instructions for wings or fuselage.
 
Last edited:
Back
Top