What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Garmin data bus setting for GDU46x -> GTN 750 -> GTS 800

Gaylon

Active Member
I am configuring the GTS 800 to work with a G3x Touch and I find in the G3x install manual (190-01115-01, page 27-43 of Rev AM) a setting I can not locate in the GTN-750. I suspect the only place to find this setting is through some Garmin Windows software program (the GTS 8XX Install Tool, Garmin P/N: 006-A0242-00) according to the GTS80 install manual.

The question is:
Where does a person find “Traffic Display Destination” and then set “Enhanced Com Port” to RS232 Port 2? Who else has this installation and what did you use for setting up the GTS800, GTN750, GDU46x?

See below guidance from the G3X manual.

CONFIGURATION GUIDANCE GTS 8XX - ALL INSTALLATIONS
A.UNDER "TRAFFIC DISPLAY DESTINATION", SET "ENHANCED COM PORT" TO RS-232 PORT 2
B.ON CONFIGURATION PAGE SET "ADS-B RECEIVER" TO "ON" AND CHECK "ALLOW ADS-B IN STANDBY

I have set the GDU460 to GTS INSTRUMENT DATA.

Any suggestions? I have pictures but haven’t uploaded yet.
 
Back
Top