Section 15 in the manual states: "Assure compliance with the wheel alignment specification presented in Section 10 of this manual".
I don't see any specs in Section 10, other than since March 1993 all alignment drilled was performed at the factory.
Not knowing if my project was from before or after that date, I'd like to verify alignment.
I've looked at the threads on how to correct mis-drilling, but didn't see actual specs.
So what are the specs for the RV-4 and how are they measured? Weight off on on wheels, tail up/down?
Finn
I don't see any specs in Section 10, other than since March 1993 all alignment drilled was performed at the factory.
Not knowing if my project was from before or after that date, I'd like to verify alignment.
I've looked at the threads on how to correct mis-drilling, but didn't see actual specs.
So what are the specs for the RV-4 and how are they measured? Weight off on on wheels, tail up/down?
Finn