Hi All, didn't find what i looked for in this forum... In preparation for first flight i sealed all that small leaks in the upper and lower baffling. Then i recognized a huge gap on the rear and lower part of cylinder 3 and 4. It's hard to see, I even had trouble to get my cell phone into place to make a pic.
The gaps are between the crank case and the lower "circle shaped" baffles that cover the inner portion of the cylinders. The gaps protrude pretty far to the top. I could throw at least three tubes of RTV on the problem but not sure if that is the correct way to deal with it. I see no chance to rivet something on.
What did you guys do here?
Any help is very appreciated.
Cheers
Kay
The gaps are between the crank case and the lower "circle shaped" baffles that cover the inner portion of the cylinders. The gaps protrude pretty far to the top. I could throw at least three tubes of RTV on the problem but not sure if that is the correct way to deal with it. I see no chance to rivet something on.
What did you guys do here?
Any help is very appreciated.
Cheers
Kay