JC/ELP
I'm New Here
I've just started construction of the vertical stab and have already run into an issue. The VS-1211 hinge spacers have a slight bow to them. When clecoed between the hinge brackets, there is nearly a 1/32 inch gap at the top of the assembly on the "concave side" of the spacer.
Is it important that these parts sit flush? I'm wondering if I should attempt to flatten the spacers or even order new ones.
BTW, I'm a total beginner with no shop experience.
Thanks for any help.
JC
Is it important that these parts sit flush? I'm wondering if I should attempt to flatten the spacers or even order new ones.
BTW, I'm a total beginner with no shop experience.
Thanks for any help.
JC