Has anyone had the 1 amp fuse on the AV-50001 Switch/Fuse Module that goes to pin 16 (VREG) on the connector fail? If so, what do you think caused it to fail - inadvertent short? What is the fuse intended to do - protect the wire in the harness and on to the master switch? More importantly, how did you fix it? It is soldered into the board and not intended to be replaced!
If I am not mistaken this supplies voltage through the master switch to the control pin (C) on the Ducatti voltage regulator, which won't function without voltage to that pin.
There has been talk about placing a jumper wire from pin C to the Batt++ terminal to solve this (apparently as is done on the Silent Hektick regulator). But does this have some negative consequences? I'm considering placing a jumper wire around the fuse on the board and then installing a small 24 ga wire on the harness outside on the module as a fuseable link, or maybe a replaceable 1 amp fuse. Thoughts?
If I am not mistaken this supplies voltage through the master switch to the control pin (C) on the Ducatti voltage regulator, which won't function without voltage to that pin.
There has been talk about placing a jumper wire from pin C to the Batt++ terminal to solve this (apparently as is done on the Silent Hektick regulator). But does this have some negative consequences? I'm considering placing a jumper wire around the fuse on the board and then installing a small 24 ga wire on the harness outside on the module as a fuseable link, or maybe a replaceable 1 amp fuse. Thoughts?