I?m preparing tank attachment points and it appears the plans come to a dead end in respect on how to treat the #19 holes along the tank edges ( pg 18-09 fig. 1- green circle) and the nutplate screw holes (Pg 18-06 fig 1, blue arrows and 18-09 orange dots) along the inboard edge attachment points
My thoughts are to dimple the tank edges to a #8 screw dimple and Countersink the #19 holes for the nutplate screws once the nutplates are riveted in place.
The deletion of specific instructions may be where Vans has intentionally omitted a production step because they think you should be able to figure it out for yourself.
Has anyone else came to this pause in the plans or am I missing something?
Thanks
Jt
My thoughts are to dimple the tank edges to a #8 screw dimple and Countersink the #19 holes for the nutplate screws once the nutplates are riveted in place.
The deletion of specific instructions may be where Vans has intentionally omitted a production step because they think you should be able to figure it out for yourself.
Has anyone else came to this pause in the plans or am I missing something?
Thanks
Jt