decision pretty much made for me by previous kit owner/builder - I see no reason to change now, having read mostly good things here about AKZO. Since every bit of the airframe built to this point is inside-primed already, it makes little sense to stop short of priming the whole interior, and not just the fay surfaces as I would otherwise have done if starting from scratch. But I still get to figure out my own surface prep regimen before shooting the green stuff.
Just last night I was reading over the instruction manual and fingering my new Harbor Freight HVLP spray gun. Wife thinks I'm a bit of a slow learner. "You're still looking at that same piece of gear an hour later?"
What are you considering priming your 10 with?